Hotspot service (Nebula Control Center already supports hotspot services such as Voucher, Walled garden) AP controller (Nebula Control Center should be used as AP controller instead) Please also note that there are some limitations and the following feature are not yet available on the cloud mode for the USG FLEX: Once connected to Nebula, the device will be configured automatically with Nebula default settings. Note: Your device must be reset to default in order to connect it to Nebula, losing all previous settings that might have been configured. How to register your firewall into Nebula (Videos)ġ.1 Register in Nebula using ZTP URL mode (09:02)ġ.2 Register your device in Nebula using ZTP USB mode (01:58) Execute ZTP Process 6.1 Activate the Firewall cloud capability via URL 6.2 Activate the Firewall cloud capability via USB 7. Troubleshooting 8. Register the Firewall and choose the deployment method 5.1 Zero Touch Provision mode 5.2 The Nebula native mode 6. Configure the Firewall in the Nebula portal 4.1 Port Group settings 4.2 Configure WAN settings if you have a static IP 5. Choosing Nebula Mode through Web GUI 2.1 Nebula ModeĢ.2 Migrating from on-premise to Nebula mode 3. How to register your firewall into Nebula (Videos) 2. It is divided into different sections, so please navigate to the relevant section for you in the table of content. This article shows how to register your firewall in Nebula. This guide shows how to add the device on Nebula using the ZTP process and pre-configure the firewall settings on Nebula, before delivering the device for the on-site installation. The ATP series can be managed in NCC from ZLD5.10 firmware. Our USG FLEX firewall can be managed and provisioned by Nebula Control Center (NCC) from ZLD5.00 firmware and onwards.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |